Analisis dan Penanganan Kerusakan Bantalan Gelinding pada Transmisi Cycloidal Disc Mesin Co-Extruder

Authors

  • Entus Abi Darda
  • Indra Tedjakumala

DOI:

https://doi.org/10.33021/jmem.v1i01.32

Abstract

Abstract. This research is discribe about the analysis and damage handling of rolling bearings in the Cycloidal Disc transmission of Co-Extruder machine. Analysis of damage process is include all factors that cause damage to the bearings and identified by using a causal diagram. The identification results showed that the most dominant factor for damage to the bearings and eccentric bearings supporting the transmission of Cycloidal Disc of Co-Extruder machine is the lifespan of the bearings that are short. In the calculation of dynamic loading, the bearing support has a weight 21312.5 N and eccentric bearings have a load of 42.625 N with the age of 4.9 months and 15.9 months. Therefore, the investigation was done by load calculation that was to replace the pads with age calculation 20.000 work hours. From the calculation results obtained the supporting bearings and eccentric loading has age of 31.9 months and 62.4 months.

Keywords. Analysis, Damage, Rolling bearing, Cycloidal Disc, Co-Extruder.

References

Blagojević, Mirko et al. 2011. “Stress and State of Single Stage Cycloidal Speed Reducer.” dalam Jurnal: The 7th International Conference Research and Development of Mechanical Elements and Systems. Serbia.

Darali. 2012. “What a Cycloidal Speed Reducer?.” dalam Darali Drives ISO 9002. Taiwan: Darali Group.

FAG. 2014. “Online Catalogue.” Germany: Schaeffler.

Ferdinand. 2008. “Perancangan Transmisi Cycloidal Disc dengan VDI 2221.” dalam Skripsi. Januari. Jakarta.

Kabra Extrusiontechnik Ltd. 2012. Pipe Extrusion Lines. India.

Kumala, Indratedja. 2008. Dasar Perencanaan Elemen Mesin. Jakarta: Universitas Trisakti.

NSK. 2013. Rolling Bearings Catalogue. Japan: NSK Ltd.

PT. Pralon. 2013. “Laporan Maintenance.” Karawang.

SKF. 2013. Rolling Bearings Catalogue. Sweden: SKF Group.

Sumitomo Drive Technologies. SM-CYCLO Gearmotors 4000 Series Technical Information. USA.

Downloads

Published

2016-04-27

Issue

Vol. 1 No. 01 (2016): Journal of Mechanical Engineering and Mechatronics

Section

Articles

License

Authors who publish with this journal agree to the following terms:
  1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
  2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
  3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).