Integrated Electrical Design of Hybrid On-Grid Photovoltaic System using QElectroTech for Residential Building

Penulis

DOI:

https://doi.org/10.33021/zbdpmc21

Abstrak

The increasing electrification of residential buildings, including the adoption of electric vehicle (EV) charging, requires electrical systems capable of integrating conventional household loads with distributed renewable-energy resources. This study presents an integrated electrical design of a Hybrid On-Grid Photovoltaic System for a residential building in the Cikarang area, Indonesia. The proposed system integrates photovoltaic generation, battery energy storage, a three-phase hybrid inverter, utility-grid support, smart metering, electrical protection, a water pump, and a residential EV charger. An engineering-design approach was applied through residential load assessment, photovoltaic and battery sizing, inverter selection, conductor and protection-device selection, and analytical design verification. Based on an estimated daily residential energy demand of 22.55 kWh/day and a simultaneous peak load of 4.14 kW, the minimum photovoltaic capacity was calculated as 5.91 kWp. A 6.48 kWp photovoltaic array consisting of twelve 540 Wp modules was therefore selected. The minimum battery requirement was 6.58 kWh for a four-hour critical-load backup target, while a 51.2 V, 200 Ah LiFePO4 battery bank with a nominal capacity of 10.24 kWh was selected. A 6 kW three-phase hybrid inverter was selected from a minimum calculated requirement of 5.18 kW. The design also incorporates a 3.3 kW residential EV charger and a 750 W water pump, with dedicated consideration of peak demand, starting current, conductor capacity, circuit protection, and surge protection. The calculated and selected component ratings were subsequently represented in an integrated QElectroTech electrical schematic. The analytical verification confirms that the selected component ratings satisfy the defined design requirements. The study is limited to analytical sizing and electrical schematic development; dynamic simulation, V2H/V2G operation, optimized EV charging, and experimental performance validation remain outside its scope.

Keywords: Hybrid On-Grid Photovoltaic System, Residential Building, Battery Energy Storage, EV Charging, QElectroTech

Biografi Penulis

  • Julu Muhammad Indra, Universitas Presiden

    He is currently pursuing the B.Eng. degree in electrical engineering at Universitas Presiden, Cikarang, Indonesia. His research interests include power systems, renewable energy integration, energy infrastructure, and electric vehicle power systems. He has experience in power system analysis, hybrid energy optimization, embedded systems, and electrical system design through various academic and applied research projects.

  • Mohammad Jabar Ariziq, Universitas Presiden

    He is currently pursuing the B.Eng. degree in electrical engineering at Universitas Presiden, Cikarang, Indonesia. His research interests include power systems, renewable energy integration, energy infrastructure, and electric vehicle power systems. He has experience in power system analysis, hybrid energy optimization, embedded systems, and electrical system design through various academic and applied research projects.

  • Andika Nainggolan, Universitas Presiden

    He is currently pursuing the B.Eng. degree in electrical engineering at Universitas Presiden, Cikarang, Indonesia. His research interests include power systems, renewable energy integration, energy infrastructure, and electric vehicle power systems. He has experience in power system analysis, hybrid energy optimization, embedded systems, and electrical system design through various academic and applied research projects.

  • Guo Yijie, Universitas Presiden

    He is currently pursuing the B.Eng. degree in electrical engineering at Universitas Presiden, Cikarang, Indonesia. His research interests include power systems, renewable energy integration, energy infrastructure, and electric vehicle power systems. He has experience in power system analysis, hybrid energy optimization, embedded systems, and electrical system design through various academic and applied research projects.

Diterbitkan

2026-10-24

Terbitan

Bagian

Articles

Cara Mengutip

Integrated Electrical Design of Hybrid On-Grid Photovoltaic System using QElectroTech for Residential Building. (2026). Journal of Electrical And Electronics Engineering, 4(1), 12-19. https://doi.org/10.33021/zbdpmc21