Interactive Smart Angklung based on Arduino with Playback and Record Mode

Penulis

DOI:

https://doi.org/10.33021/rx9jfv37

Abstrak

Learning a traditional musical instrument can be challenging for a beginner. The combination of smart technology based on sensors and microcontrollers with the angklung can facilitate learning. In this research, a Smart Angklung system was developed. The system operates in two modes: Playback and Record, allowing users to play without needing to reprogram the system. In Record mode, players play the angklung as usual while touching a sensor attached to each tube. This performance is saved onto an SD card. In Playback mode, linear actuators drive the angklung according to the recorded data. The control center is powered by an Arduino Mega 2560, and recorded data is stored using an SD card module. Based on this data, DC motor-based central door locks serve as linear actuators to move the angklung tubes. The system functions properly with a maximum error in note duration deviation of less than two seconds.

Biografi Penulis

  • Iksan Bukhori, Universitas Presiden

    He received the bachelor’s degree in control systems from President University, Indonesia, in 2013, and the Master of Philosophy degree in electronic system engineering from Universiti Teknologi Malaysia, Malaysia, in 2017. He is currently a Lecturer with the Electrical Engineering Department, Faculty of Engineering, President University. His research interests include control systems, robotics, artificial intelligence, and embedded systems

Diterbitkan

2026-10-24

Terbitan

Bagian

Articles

Cara Mengutip

Interactive Smart Angklung based on Arduino with Playback and Record Mode. (2026). Journal of Electrical And Electronics Engineering, 4(1), 32-36. https://doi.org/10.33021/rx9jfv37